For the flame radiation analysis, a well approved integral procedure in the respective spectrum is carried out with the compact flame controller. After a pre-amplification, the unwanted CW light component is withdrawn from the output signal of the wear-resistant detector.
The subsequent sensitiveness attitude allows an attenuation of the signal for adaptation to the combustion process. The post-connected band pass filter caused, that only the typical modulation of the flame radiation of the primary combustion zone is valued and so extraneous light signals by neighbour burners can be distinguished from the own flame. Further functional groups include signal conditioning and other for the so-called dynamic monitoring channel which checks the fail safe function of the device continuously. A component or component defect leads to an immediate disconnection of the flame relay, which one is available as a floating change-over contact for use with the burner management system. The switching condition is announced additionally by a yellow LED on the reverse side of the device behind the Perspex pane. For the optimal adjustment of the compact flame controller the flame strength can be read off directly on the device by means of a pulsating green LED. For the visualization or remote indication, a current output is available at 0 or 4-20 mA. The safety switch-off time, which is based on the used fuel, is factory-adjusted to 1 second.
Flame scanner with integrated flame amplifier and flame relay.
TÜV approved, DIN-DVGW, CSA and UL listed, SIL3 certified
For intermitted, continuous operation
Type UV, UV1: For natural gas-, oil- and dual fuel operation
Type IR (VIS-IR): For oil flames on diffusion burners
Type IR2 (IR): For selective monitoring of gas- and oil burners
Type IR3 (IR): For different fuels, oil, waste gases, duct burners
Dual-channel flame monitoring system
Analogue output 0(4) – 20mA Intensity
Possible flame evaluation by software CFC-COM
Switch-on threshold and switch-off threshold adjustable by software CFC-COM
gain factor adjustable by software CFC-COM
Status indication of flame relay and intensity by LED
Class of protection IP 65.
ATEX Zone 2 as standard
optionally ATEX Zone 1
CFC1000UV or UV1: natural gas, oil and mixed fire
CFC1000IR (VIS-IR): Oil and coal dust monitoring also mixed burners
CFC1000IR2: Gas flame on surface burners and reheating
CFC1000IR3: Selective monitoring of gas and oil burners
Sulfur recovery (Claus process)
fluidised bed combustion
Low NOx applications
For more information on this Compact Flame Controller please call or use the IndustrySearch email enquiry for a direct reply.
Burner overhauls & servicing
Oil burners & Gas burners
Next Generation "Burner Management Systems" agents for ANZ, SE Asia & The Pacific
Factory Trained agents for BFI Flame Scanners in ANZ.
Burner tips, sprayer plates, caps, & plugs.
Ignitors, overhauls, troubleshooting, and supply.
Burner commissioning and certification