Signal Conditioning Unit | RM-044 Get latest price

Read more...

To contact Applied Measurement Australia about Signal Conditioning Unit | RM-044 use Get a quote.

The RM-044 has been designed as a low cost, stand-alone unit to provide signal conditioning for strain gauge type transducers such as Pressure Transducers and Load Cells.
Supports Stain Gauge work

½ Bridge and ¼ bridge 120 ohm and 350 ohm strain gauges. Internal Bridge completion supplied. Gain selection and gross offset correction and all internally link selectable.

The electronics is housed in a 100 x 115 x 20 mm-plastic housing.

Four, three 3-pin connectors are provided for signal, transducer and power connections. The RM-044 is normally supplied to provide + 10 volts output for the full range of the transducer but the output will drive over the full range of ± 10 volts. The output is also configured to provide 4 to 20mA signals if required.
 
SPECIFICATIONS:

• Power Supply:                         +24 Volt Nominal. (18 To 30 V). (Optional 12 V)
• Transducer Excitation:            +1.3 -> +10 VOLT @ 50 mA MAX.
• (Or +/- 15 Volt unregulated @ 15 mA Max. Link selectable).
• Excitation Stability:                0.02 % / °C
• Input Impedance:                    > 100 M ohm (Differential)
• CMRR:                                   100 dB @ 50 Hz
• Linearity:                                 0.01 %
• Gain Range:                            120 TO 3200
• Frequency Response:              10 Hz Or 20 kHz 4 Pole Max Flat (Factory Configured)
• Outputs:                                  ± 10 VOLTS @ 5 mA MAX.
• 4 TO 20 mA (500 ohm MAX).
• Output noise:                          1 mV RMS.
• Environmental                         -25 TO 75 °C 90% R.H. N/C.
• Physical:                                  100 x 115 x 20 mm (LWH)

Read less...

To contact Applied Measurement Australia about Signal Conditioning Unit | RM-044 use Get a quote.